SE-Connect mode is supported only on SE models withĬisco IOS access points are shipped from the factory with Cisco as the default enable password. SE-Connect: In this mode, the AP provides a dedicated connection toĬleanAir for spectrum analysis by software such as Spectrum Expert orĬhanalyzer. These packets are tunneled inĬAPWAP to the controller, which forwards them to a machine running OmniPeek Sniffer: In this mode, the AP radio operates in promiscuous mode andĬaptures all Wi-Fi traffic on a channel. Supported on Cisco Wave 2 or 802.11ax APs and is deprecated. Monitors the LAN to detect on-wire rogue activity. Rogue Detector: In this mode, the AP radios are disabled the AP Wi-Fi channel for RRM and rogue detection. Monitor: In this mode, the AP radios are dedicated to monitoring the Not all AP models support these modes see the relevant mesh documentationįor information about support for mesh operation. Where wireless rather than wired backhaul is used for CAPWAP connectivity. Allīridge and Flex+Bridge: These modes are used in mesh deployments, FlexConnect mode APs do not support mesh operation. All AP models support LocalįlexConnect: In this mode, client traffic can either be tunneled inĬAPWAP to the controller, or egress at the AP’s LAN port, depending on the
Local mode APs do not support mesh operation. Radios are operational only when the AP is connected to its controller. Traffic, for all WLANs, in CAPWAP, to the controller. Some modes, the AP provides network service to clients in other modes, the AP operates Each lightweight AP is configured to operate in one of several different AP modes.
0 kommentar(er)
